Have you realized that a sprinkler system in cold weather for landscape design for small spaces and large spaces is at risk of damage when the temperature dips too low?
Your sprinkler system might be damaged by freezing temperatures without proper preparation for the winter.
All it takes is a few precautions and you will save your sprinkler system from cold weather damage. Follow the below-mentioned 5 amazing hacks that can protect your irrigation system from winter damage.
Plan consistent with the Weather
It would be adequate if you pay close attention to the pattern of temperature drops to have an idea of when to start winterizing the system.
If there is a sudden drop for only one night before temperatures spike again, you can protect the irrigation system by exposing pipes.
Ultimately, it is best to prep your irrigation system before the primary deep frost, snowfall, or night when the temperature will drop below 32° F. Plan beforehand to wrap insulation to protect the irrigation system from harsh winter temperatures and prevent it from freezing.
Park pivots during a safe location
When choosing a location to park the system for the winter, consider the three commonest potential sources of winter damage:
- Wire theft is a smaller amount likely during a visible but inaccessible area of the field
- Wind damage is less significant if the pivot points into or far away from the wind direction instead of perpendicular to the wind direction.
- Squirrels and other rodent damage to span wire are rare when pivots are a couple of hundred feet from the timberline.
Manual Valves
If your sprinklers have manual drainage, you’ll get to open up all of the vents on your own to empty the system.
The primary step is to show off the water system. There should be a backflow device that will prevent water from flowing back to the house.
Then you only let gravity do its thing and propel the water out of the pipes on rock bottom points of your system.
Don’t forget to check valves or backflow devices that will prevent water from flowing freely out of the system.
Once the water is completely draining, turn off the valves. You can add some antifreeze into the pipes to stop this from happening.
4. Block the comb and branches near the equipment
Trimming trees and removing brush near control panels and disconnect boxes reduces the prospect of rodent damage. Removing woodchucks from the vicinity of pivot and pumping plant pads or electrical boxes also can help prevent damage.
At times, squirrels and chipmunks tend to damage span-wire which can be avoided by removing limbs near equipment parked for the winter, preventing animals from jumping between trees.
5. Drain Pipes
Removing water from the pipes and system in winters is crucial in preventing them from freezing and expanding, which ends up in burst pipes.
There are three methods used for draining pipes: a manual drain valve, an automatic drain valve, and therefore the compressed gas blow-out methods.
When can you stop irrigating?
You will need to stop irrigating your landscape until after the sun rises and begins to heat the ground. Also, don’t irrigate when the ice is melting and temperatures are above freezing and rising.
This happens when the temperature is above freezing and rising. Beware of sudden dips in the temperature soon after sunrise.
Are you an
Entrepreneur or Startup? Do you have a Success Story to Share? SugerMint would like to share your success story. We cover entrepreneur Stories, Startup News, Women entrepreneur stories, and Startup stories
|
We hope the above-mentioned tips help you in protecting your irrigation system from winter damage. If you want an irrigation company Westchester county, get in touch with us.